With the rapid growth of the market, more and more people are diving into solo home mining. However, this surge raises a question: "How can I fine-tune my setup to keep my devices running at peak performance?" If this has been driving you up the wall, this blog might just save your sanity.
For a geeky tech product, beginners often get confused about terms like "frequency" and "core voltage" For short answer, the "frequency" refers to a chip's processing speed - higher frequency theoretically enables faster computations. "Core voltage" is the electrical power delivered to the chip - higher frequencies typically require increased voltage. Think of it like an athlete: Just as a weightlifter needs adequate nutrition to maintain performance, a chip requires proper voltage to sustain higher frequencies.
However, we can't blindly increase frequency and core voltage to gain higher computing power, as this is constrained by another critical factor: heat generation. Higher frequency and voltage inevitably produce more heat, which is most visibly reflected in the elevated power readings shown in the image below:
Excessive temperatures can lead to system instability and potential hardware damage. Therefore, device optimization is essentially about finding the right balance between frequency, core voltage, and power consumption - a complex tripartite relationship.
Someone might ask: "Is there a golden ratio configuration?" The answer is NO—even devices of the same model may vary between production batches. That's why in our upcoming v2.7.0 major update, we've added a feature specifically for beginners: three preset operation modes (shown below)—ECO, Normal, and Performance. Users simply need to select their preferred mode.
Depending on each device's unique characteristics, fine-tuning may sometimes be necessary. Taking the Zyber8S as an example:
-
When Performance Mode is selected:
-
Frequency: 600MHz
-
Core Voltage: 1250mV
-
Based on our actual testing, this configuration typically results in:
-
Power Consumption: 120-130W
-
Temperature: 50-58°C
-
-
Adjustment Scenarios:
-
If power exceeds 150W:
-
Manually reduce core voltage to 1200-1220mV.
-
Steps:
① Click "Enable Overclock Mode" to activate manual settings.
② Enter 1200 and save.
-
-
If performance is low (~5.6TH/s) despite normal readings:
-
Slightly increase core voltage to 1270mV.
-
This may raise power consumption, but remains safe as long as temperature stays below 80°C.
-
Once fine-tuned, these settings rarely require further adjustments.
发表评论
所有评论在发布前都会经过审核。
此站点受 hCaptcha 保护,并且 hCaptcha 隐私政策和服务条款适用。